Lace Wrap

A great Lacy Wrap with a ZigZag pattern from Premier Yarns!

Finished Measurements:

16" x 59" (excluding fringe)

Materials

Yarn:

Serene by Premier Yarns – 1 ball desired color

(90% acrylic/10% polyamide; 656 yards/600 meters; 10½
ounces/300 grams)

Knitting Needles:

US 8 (5mm)

Extras:

Yarn needle, crochet hook for attaching fringe

Gauge

16 sts and 23 rows = 4" in Zig-Zag Lace Patt.

Use any size

needles necessary to obtain the specified gauge.

ShawlCast on 66 sts.

Knit 8 rows. Beg Zig-Zag Lace Patt as follows.
Row 1 (WS):
* P3, k2tog, yo; rep from * to last st, p1.

Row 2 and all RS rows:
Knit.

Row 3:
P2, * k2tog, yo, p3; rep from * to last 4 sts, k2tog, yo, p2.

Row 5:
P1, * k2tog, yo, p3; rep from * to end.

Row 7:
P1, * yo, sl 1, k1, psso, p3; rep from * to end.

Row 9:
P2, * yo, sl 1, k1, psso, p3; rep from * to last 4 sts, yo, sl 1, k1, psso, p2.

Row 11:
P3, * yo, sl 1, k1, psso, p3; rep from * to last 3 sts,
yo, sl 1, k1, psso, p1.

Row 12:
Knit.
Rep Rows 1-12 of Zig-Zag Patt until piece measures approximately 57" from beg.
Knit 7 rows. Bind off loosely.
Finishing
Cut 16" lengths of yarn. To attach fringe in each st along both short edges of shawl, fold yarn strand in half to create a loop, use crochet hook to pull loop through st, pull yarn ends through loop and tighten.

Use yarn needle to weave in loose ends.
 

Lighter Than Air Shrug

Lighter than air, yet so warm and amazing!

SIZE: One Size
About 19%" (49 em) wide and 52"(132 em) long,after blocking, but before tucks. With selvedges allowed to roll,piece will measure about 18" (45.5 em) wide.

MATERIALS • 484-133 Lion Brand LB Collection Silk Mohair: Sunset 2 Balls• Lion Brand Split Ring Stitch MarkersLarge-Eye Blunt Needle

• Additional Materials Size U.S. 8 (5 mm): two 24 in. (60 em) circular
GAUGE:
17 sts and 17 rows= 4" (10 em) in St st,after blocking.
BE SURE TO CHECK YOUR GAUGE. When you match the gauge in a pattern, your project will be the size specified in the pattern and the materials specified in the pattern will be sufficient. If it takes you fewer stitches and rows to make a 4 in. [10 em] square, try using a smaller size hook or needles; if more stitches and rows, try a larger size hook or needles. 
 
NOTES:
Here are some tips for working with this little beauty: Though most yarn of this type is put up in pull balls or skeins, take time to roll it into balls. Place the wound ball inside a small ziplock bag and "zip" all but an inch of the top so the yarn can feed through freely. This keeps the yarn
clean and tangle-free and works especially well if you're working with multiple strands of yarn
(either double strands of silk/mohair or silk/mohair plus another yarn). To deal with a mistake that is difficult to rip back,or if your work has fallen off your needles, place the entire piece
along with the working yarn in a large ziplock bag, then place it in the freezer for10 minutes or so until the fibers firm up but not so long that ice crystals form. The cold fiber will be easier to detangle or replace on the needles. Use a lifeline if you are concerned about the stitches slipping off the needles. Periodically (say, at the end of each pattern repeat) draw a tapestry needle threaded with a strand of thin smooth yarn or dental floss through the stitches on the needle. On the next row,take care not catch the lifeline into the knitting. If you do make a mistake,simply ravel to the lifeline. If you use a set of interchangeable needles, thread dental floss into the hole at the base of the needle and knit a row as usual-the lifeline will be added as you knit.Shrug

Using the Invisible method and substituting a second clr needle for the waste yarn CO 82 sts.

 Note:   Work even in St st (K RS rows, P WS rows) until piece measures 52 1/2" from CO. Cut yarn, leaving a 60" tail to use for grafting later. Leave sts on needle.

FinishingWith clr needles in place as holders at each end of piece, wetblock to 19 1/4" wide and 52 1/2" long, using blocking wires on long edges if desired. Allow to air dry thoroughly.TucksFor the first set of tucks, find the centerline of the St st rectangle- 41 sts on each side of center. Mark a series of tucks along this centerline as foll: Beg at end with last row of sts worked, measure down 3 3/4" from the cir needle holder and place a removable marker directly in the fabric, then measure down7'1/2'' (19 em) directly below the previous m and place a removable min the fabric] 6 times-7 markers along centerline; the top and bottom mare each 3%" (9.5 em) from the end of the fabric.
For the second and third sets oftucks,count in 10 sts from the selvedge along each long side. Mark a series oftucks along the line at each side,10 sts from the selvedge,as foil: Beg at end with the last row of sts worked,measure down 7112'' (19 em) from the cir needle holder and place a removable m directly in the fabric,[then measure down 71h" (19 em) from previous m and place a removable min the fabric] 6 times-14 side markers total; 7 markers at each side placed 10 sts in from the edge; the bottom mat each side is just above the needle holding the provisional COsts.To sew the center tucks, thread a length of yarn on a tapestry needle and anchor it securely to the WS at a marked centerline position. With RS of fabric facing you,bring the needle up through the fabric from WS to RS 7 sts to the left of the marked position. Skim the needle through the st that is 7 sts to the left of the marked position,then through the stat the marker, then through the st that is 7 sts to the right of the marked position-3 sts caught on the tucking strand. Pull strand to draw the 3 sts tog,then sew through all 3 sts again 8 to 10 times using an overhand st. Fasten yarn invisibly on WS under the tuck. Work a center tuck at each of the rem 6 marked centerline positions.
To sew the side tucks along the right-hand edge of the fabric, thread a length of yarn on a tapestry needle and anchor it securely to theWS at a marked position. With RS of fabric facing you,bring the needle up through the fabric from WS toRS 10 sts to the left of the marked position. Skim the needle through the st that is 10 sts to the left of the marked position, then through the stat the marker,then through the selvedge st that is 10 sts to the right of the marked position-3 sts caught on the tucking strand. Finish as for center tuck. Work a tuck at each of the rem 6 marked positions along the right-hand edge of the fabric.To sew the side tucks along the left-hand edge of the fabric, thread a length of yarn on a tapestry needle and anchor it securely to theWS at a marked position. With RS of fabric facing you,bring the needle up through the fabric from WS toRS 10 sts to the right of the marked position. Skim the needle through the st that is 10 sts to the right of the marked position, then through the stat the marker,then through the selvedge st that is 10 sts to the left of the marked position-3 sts caught on the tucking strand. Finish as for center tuck. Work a tuck at each of the rem 6 marked positions along the left-hand edge of the fabric.Join short ends.
Hold cir needles parallel with WS touching and RS facing out,being careful not to twist piece. Use the Kitchener st forSt st to graft the live sts at the ends tog.

Back Seam
Lay piece flat with selvedges running horizontally across the top and bottom and the Kitchener join
positioned vertically in the center of the side facing you. Measure out 41h" (11.5 em) on each side of the join along the top edges and pin both layers tog at these points. With yarn threaded on a tapestry needle,use the mattress st to sew the two layers tog between the marked points.There will be about 8112" (21.5 em) left unsewn at each side of the top edge; these unsewn sections form the armholes.
Weave in loose ends.







 

New Year's Eve Knitted Jewelry

Bring in the New Year with your own style! Knit up something gorgeous!

SIZE One Size

MATERIALS
1 ball S. Charles Collezione
STELLA 74% silk, 26% lurex (0.88oz/25g; 76.5yds/70m) in color
#04 starry night (A) 1 ball S. Charles Collezione
CRYSTAL 85% polyester, 15% cotton (0.88oz/25g; 144yds/131m) in color #04 sunbeam (B)
One pair size 3 (3.25mm) needles OR SIZE TO OBTAIN GAUGE
• One pair size 2 (2.75mm) needles

• Two toggle clasp sets

• Black thread

• Beading needle

• Yarn needle


KNITTED MEASUREMENTS

Necklace
⅝" x 16½"/1.5cm x 42cm
Bracelet
1¼" x 7"/3cm x 18cm

GAUGE 32 sts and 30 rows = 4"/10cm in Garter stitch using A and larger needles TAKE TIME TO CHECK GAUGE
SPECIAL ABBREVIATION
K1-f/b: (RS)
Knit 1 front and back (inc) - Knit next st, then knit it tbl.
K2tog: Knit 2 together (dec) – Knit 2 sts tog through the front loops.

PATTERN STITCH

Garter stitch (Garter st) Knit all sts every rows.

 

NOTE: Slip the first stitch of each row knitwise to create a nice even edge.
ROSE
With A and smaller needles, cast on 40 sts.
Row 1 Change to B and knit.
Row 2 Knit.
Row 3 K1-f/b in each st – 80 sts. 
Row 4 K1-f/b in each st – 160 sts
Row 5 Knit.Row 6 K1-f/b in each st – 320 sts.Bind off all sts. Gather cast-on edge to give the shape of a rose and sew it tog with black thread.
NECKLACE
 
With A and larger needles, using a long-tail cast on, cast on 3 sts directly onto the clasp as follows: use the beading needle to thread the yarn through the hole of the clasp from back to front and cast on 1 st, tightening the yarn around the ring. Before casting on the next st, pull the short tail through the ring again from back to front and rep for the rem 2 sts.
Row 1 Knit.Row 2 K1, k1-f/b, k1 – 4 sts.Row 3 K1, k1-f/b, k2 – 5 sts.Work even in Garter st, slipping the first st of each row, until Necklace measures 16¼" or desired length.
Dec Row 1 K1, k2tog, k2 – 4 sts rem.
Dec Row 2 K1, k2tog, k1 – 3 sts rem. 
 
Cut yarn leaving a 10" tail.

Bind off directly onto the other side of clasp as follows: thread tail onto beading needle and pull it through the loop of the clasp from back to front. Push clasp close to the st on needle and knit the st. * Making sure the clasp stays close to sts, pull tail through clasp again from back to front and knit the next st. Pass the 1st st on the RH needle over the 2nd st and off the needle to bind off. Rep from * until all sts are bound off.

Weave in tail.

Sew Rose to center of the Necklace with black thread. Weave in ends.


BRACELETWith larger needles and casting on sts directly onto the clasp as for Necklace, cast on 2 sts with A, 3 sts with B, then 2 more sts with A – 7 sts.
Work even in Garter st, slipping the first st of each row and twisting yarns tog at each color change, until Bracelet measures 6¾" or desired length.


Cut yarn leaving a 15" tail.

Bind off all sts directly onto the other side of clasp as for Necklace. Weave in ends.